๐Ÿ†Ž AusBoss ยท examples

Swap didn't work? Check these first

For the Pika Remix and Person Swap workflows. Most problems are one of the few things on this page. Start at the top.

I got my own clip back

the person did not change
  1. Say who goes on the first line, by how they look in your clip.
  2. Say what the new person looks like on the second line. It must start a new line.
  3. Describe what is different about the new person. If your words also fit the person already in the clip, nothing tells the model to change them.
  4. Clothes go inside that same line. A separate "@1 is wearing" line is left out.
Replace the man in the checked shirt with @1.
@1 looks like a man with short curly brown hair and glasses, wearing a black suit.
  1. Use one clear front photo with the face big in the picture. A very small photo gives the model little to go on.
  2. Pick a clip where the face is big and turns to the camera at some point. A small, turned-away or covered face is the top reason the original stays.
  3. Trim the clip to one shot, 10 seconds or less (8 seconds on an 8 GB card).
  4. Try two or three seeds before you change anything else.

Don't want to write the looks line? Turn on Describe @1 for me (Person Swap) or Auto prompt (Pika Remix) and the workflow writes it from the photo. For a cartoon or a non-human character, type the line yourself.

Check what the model was told

takes ten seconds

After a run, read the box named Show Text - Prompt H3 sees. Find the line that starts <Subject 2> is the person in <Picture 1>.

  • It ends with this appearance: โ€ฆ and your words. Your looks line was read.
  • It ends with the same face, hair and clothes. No looks line was read. Put @1 looks like โ€ฆ on its own line and run again.

Errors

What you seeWhat to do
Value not in listA model file is missing or has another name. The Guide note in the workflow lists each file and its folder.
A node is red or "missing"Update AusBoss nodes (2.25.2 or newer) and restart ComfyUI. Keep only one copy of the pack in custom_nodes.
One AusBoss node is missing, the rest loadThat one file hit an error at startup. Restart ComfyUI and find the console lines that say AusBoss. They name the cause.
KeyError: 'latent' at the samplerAnother pack, muse-minimax-director, changes H3 for every workflow. Turn it off and restart.
Out of memoryPick Low VRAM under 24 GB. Keep clips to 10 seconds or less. On 8 GB you need ComfyUI 0.45 or newer and about 32 GB of system RAM.
Odd output after adding a LoRALeave Pika on at strength 1 and don't add a Turbo or Lightning LoRA on top.

Still stuck? Post these four things

and we can answer in one reply
  1. Your ComfyUI version and AusBoss version. Both are in Settings โ†’ About.
  2. Your graphics card and how much VRAM it has.
  3. A screenshot of the whole workflow after the run.
  4. The text in the Show Text - Prompt H3 sees box.

Post them in the help thread on the AusBoss Discord: Pika Remix + Person Swap: troubleshooting and tips. New here? Join the server first.

Real runs to copy from, with the clip, the photo, the exact words and every setting: Pika Remix and Person Swap. Slow renders? Make them about twice as fast.

NextFaster video โ†’
ComfyUI-AusBoss on GitHubWorkflows on CivitaiDiscordYouTube @ausbossdevClips start muted.